Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If the play button flashes on HyperDecks that record on SSDs, this means the disk is not fast
enough and playback cannot keep up. We recommend you change to a compressed recording
format such as ProRes or DNxHD, or use a faster recommended SSD for uncompressed or
Ultra HD recording.
SSD slots have rotating LEDs to show the unit is in playback mode
TIP
If you play back a video clip that has an associated .MCC file, the closed caption
data will be played out with the video via the SDI output of your HyperDeck.
Ultra HD Playback on HyperDeck Studio Pro
HyperDeck Studio Pro can play back Ultra HD video via single link 6G-SDI, dual link 3G-SDI,
and quad link HD-SDI.
To select your desired Ultra HD playback output:
1
Press the 'disp' button to open the control panel LCD menu.
2
Using the jog/shuttle wheel and 'set' button, select 'video', then '2160p SDI out'.
3
Select your desired output type and press 'set' to confirm. Press the 'disp' button to
close the menu.
Video In
2160p SDI Out
INPUT
REM
Single 6G-SDI
4K SDI Out
Quad HD-SDI
JOG
For HyperDeck Studio Pro, you can choose between single link 6G-SDI,
dual link 3G-SDI or quad link HD-SDI for Ultra HD playback
Jog or Shuttle
You can use the jog or shuttle wheel to shuttle to a particular section at variable speeds.
The more you turn it forwards or backwards, the faster your HyperDeck Studio will play through
your video. Once you've found the section you want to review, press 'play' to resume
normal playback.
If you want to slowly jog through your video frame by frame, press the 'jog' button once to
enable jog operation. Turning the jog or shuttle wheel in the desired direction will then jog
through your video. Pressing the 'jog' button again will return the wheel to shuttle operation.
Dual 3G-SDI
DISP
SET
01:42:56:12
DISP
INPUT
REM
SET
JOG
01:42:56:12
INPUT
REM
JOG
SSD
2
Playback
SSD
2
11
Publicité
Chapitres
Table des Matières
