Getting Started - Blackmagic Design HyperDeck Manuel D'utilisation Et D'installation

Getting Started

Getting Started with Blackmagic HyperDeck
Getting started with your HyperDeck disk recorder is as easy as connecting power, plugging in
your video sources and destination equipment to your HyperDeck's inputs and outputs and
inserting your SSDs or SD cards.
Plugging in Power
Simply plug a standard IEC cable to your HyperDeck's power input on the rear panel.
POWER
Connect power to your HyperDeck Studio using
a standard IEC power cable
You can also power your HyperDeck Studio Mini via Ethernet by plugging into a compatible
Ethernet switch that supports PoE+, or 'power over Ethernet plus'.
USB-C REF OUT
ETHERNET PoE+ REF IN
Connect power to your HyperDeck Mini using a standard IEC power cable.
Power can also be supplied via a PoE+ compatible Ethernet switch.
Plugging in Video and Audio
Plug your source video to the SDI or HDMI inputs, and your destination equipment to the
SDI or HDMI outputs.
HyperDeck Studio 12G has 12G-SDI connectors so you can input or output Ultra HD up to
2160p60 using a single BNC cable.
HyperDeck Studio Pro provides additional inputs and outputs for connecting video equipment
that supports single link, dual link or quad link Ultra HD.
REMOTE
ETHERNET
IN OUT
HDMI
A B
HDMI OUT SDI OUT
REMOTE IN SDI IN
Y IN B-Y IN R-Y IN
IN A IN B IN C IN D
SD/HD/3G/6G-SDI IN
Getting Started
Y OUT B-Y OUT R-Y OUT
OUT A OUT B OUT C OUT D
SD/HD/3G/6G-SDI OUT
5
REF IN
MON OUT