Maintenance And Care - Reely Bimot Notice D'emploi

18.

Maintenance and Care

Regularly check the functional safety of the transmitter and smooth running of the drive motors and the rudders. All
moving parts have to be easily movable but there should not be a clearance in the bearing.
Clean the exterior of the model and the transmitter only with a soft, dry cloth or brush. Never use any aggressive
cleansing agents or chemical solvents, since this might damage the surfaces.
Important!
If you have to replace any damaged or worn parts, only use original replacement parts.
The spare parts list is located on our website www.conrad.com in the download section to the respective product.
Alternatively, you may also request the spare parts list on the phone. The contact information is included at the begin-
ning of these operating instructions, chapter „Introduction".
Propeller change
Proceed as follows to replace a damaged propeller:
• Hold the propeller shaft with small long-nosed pliers.
• Turn the propeller manually counter-clockwise (from the front) and screw the propeller from the shaft.
• Put on the new propeller and tighten it clockwise (from the front).
56
Figure 22