Binding Function - ModelCraft GT3 2.4GHz Notice D'emploi



14. Binding Function

To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are already aligned with each other and can be used at once. Binding must be renewed
mainly after replacement of the transmitter or receiver or to remove interferences.
To perform the binding procedure, proceed as follows:
• Switch off the receiver and transmitter.
• Transmitter and receiver should be in direct proximity (distance max. 1 m).
• Disconnect any servos that may be connected from the receiver.
• Connect the programming plug (1) to the CH3 output of
the receiver.
• Switch on the receiver. The receiver LED (2) starts to flash.
• Press the Enter button at the transmitter (see figure 2,
item 11) and keep the button pressed.
• Switch on the transmitter while pressing Enter.
• When the LED in the receiver (2) stays lit permanently,
the binding procedure is completed.
• Release the Enter button at the transmitter.
• Switch off the receiver and transmitter and remove the
programming plug.
• Re-connect the servos/controls to the receiver.
• Verify the system functions and perform a range check.
If the system does not work properly, repeat the procedure.
Figure 17
53