Error messages
The Error Message menu appears when there is a fault interrupting automatic operation of the system.
To reset the error message:
Switch the main switch OFF and ON again.
•
If the error message re-appears after the main switch has been switched ON/OFF, notify the
•
aftersales service straightaway.
*1/1**error message***F* checksum
Program values saved in the EPROM (values_1)
or EPROM (standard) are incorrect. Re-start the
program by switching the main switch OFF and
ON again. If the error message re-appears after
the power plug has been unplugged and plugged
in again, notify the aftersales service
straightaway.
300108/AV/Draft
Operating Manual AC 3000-13500
*1/1**error message***F* interface
There is a problem with the TAE cable connecting
the input/output unit and display module. Check the
connections. Re-start the program by unplugging
the power plug and plugging it in again. If the error
message re-appears after the power plug has been
unplugged and plugged in again, notify the
aftersales service straightaway.
19