Pontos AquaCycle 3000-3 Instructions De Montage page 239

Change the flashing value using the
•
or buttons.
Go to the next digit of the timer value
•
using the button.
Change the flashing value using the
•
or buttons.
Confirm with the
•
Manual mode:
In the Manual Mode menu you can check the
service readiness of all the connected
consumers. All the consumers can be active at
the same time. (This should however be
avoided in normal operation!)
In the manual mode the green LED flashes.
Select the consumer to be checked
•
using the or
Confirm with the
•
To deactivate, press the
•
again.
"Operating Values" menu
In the Operating Values menu, operating
values such as times and volumes can be read.
This also includes the operating hours of the
UV lamp.
"Display" menu:
In the Display menu you can set the backlight
and contrast of the display.
Using the or
•
item wanted.
Confirm with the
•
changes to Set.
Change the value with
•
Confirm with the
•
value is saved.
"Messages" menu
System faults which do not lead to automatic
program abort are displayed in the Messages
menu. If messages are present, the red LED
"faults" shines.
Reading the messages:
In the main menu, select Messages
•
using the or
Confirm with the
•
Acknowledge the message with the
•
button.
If a fault recurs, please contact the
•
aftersales service.
18
button.
buttons.
button.
button
buttons, select the
button. The display
or .
button. The new set
buttons.
button.
Operating manual AC 3000-13500
No message
There is no fault
See annex for potential error messages
"Configuration" menu
In the Configuration menu you can select the
language of the menu navigation and in the
event of malfunction you can select emergency
mode activation.
Call the Configuration menu.
•
Select menu item using
•
buttons.
Confirm with
•
Message
or
button.
300108/AV/Draft