Pontos AquaCycle 3000-3 Instructions De Montage page 236

"Status display" menu
*1/2***Automatic**
> Start automaticpr.
Status display
Eco
*2/2***Automatic**
> Running in
Status display in "Auto" menu
The Status Display menu item indicates the
operating status of the pumps and valves as
well as the individual tank levels.
Status display, Pumps:
The Pumps menu item has three submenu
pages and indicates the operating status of the
various pumps.
Display details:
ON The pump is active
OFF The pump is not active
P3 Pressure boost
V1/2 Air pump 1/2
Status display, Valves:
The Valves menu item indicates the operating
status of the valves.
They are normally OFF
Status display, Levels:
The Levels menu item indicates the water
levels in the individual tanks and in the filter.
300108/AV/Draft
*1/2****Status display**
> Pumps
Valves
off Fill levels
*1/2****Status Display**
> UV
on
inactive.
Operating Manual AC 3000-13500
off
The min. and max. levels of the individual tanks
are shown in a table.
Display details:
0 = desired level not reached
1 = desired level reached
Running-in phase:
During the running-in phase, the
microorganisms implant themselves in the
substrate. While grey water is treated during
this phase, the system conducts it into the
drains via the sediment extractor. During this
running-in phase, the consumers are supplied
by the fully automatic drinking water top-up.
After the running-in phase (factory setting 14
days) the control automatically changes over to
automatic mode. You can end the running-in
phase manually.
*1/3****Pumps**
> P3 off
Faults off
P1 off
*2/3****Pumps**
> P2 off
V1 off
V2 off
*3/3****Pumps**
> VA1 off
VA2 off
VA3 off
*1/1****Valves****
> VA3 close
VA4 close
*1/2****Fill level**
> Stage | 1 | 2 | 3 |
N_max | 0 | 0 | 0 |
*2/2****Fill level**
> N_004 | 0 |
N_005 | 0 |
15