Commissioning; Removing The Car Body; Inserting The Driving Battery Into The Vehicle - Reely ROAD 23 72 11 Notice D'emploi


10.

Commissioning

a) Removing the Car Body
The car body is secured with fastening clamps/clips (also called car body splints) that must be pulled from the holding
pins. The car body can then be lifted off.
b) Inserting the Driving Battery into the Vehicle
Attention!
The driving battery must not be connected to the speed controller yet!
To insert the driving battery, open the battery compartment
cover on the underside.
First pull the holding clip (A) from the retaining pin (B). Then
pull the retaining pin from the chassis.
Now insert a driving battery. The connecting cable of the
driving battery is installed upwards through the opening (on
the side of the connector of the speed controller).
Re-attach the battery compartment cover properly, stick the
retaining pin (B) into the opening (either from the right or
from the left) and lock the retaining pin using the holding
clip (A) previously removed.
c) Inserting Batteries (or Rechargeable Batteries) in the Transmitter
If you have not done so already, insert rechargeable batteries/normal batteries into the transmitter. Observe the
operating instructions for the transmitter.
d) Switching on the Transmitter
Always turn the transmitter on before connecting the rechargeable driving battery with the speed controller. Check the
state of the batteries or rechargeable batteries inserted.
B
B
A
A
73