Steering - Reely ROAD 23 72 11 Notice D'emploi

c) Steering
LP
G6
• First, install the lower transverse link „G6" at the front of the
chassis. For this, a recessed head tapping screw „S2" is used (a
8mm M3 recessed head screw „S5" may be included with the
construction set instead).
• Then insert the two metal axles „MA1" into the respective
openings of the transverse link holder „G6" with the flattened
side, and attach them from the underside using one 8mm M3
recessed head screw „S5" each; see following figure.
• Screw on the ball headed screws „KK1" in both steering arms „LH1" and „LH2". Do not use any force when screwing;
this may damage the steering arm plastics.
• Use the special screws „S4" to fasten the steering plate „LP" to the steering arms „LH1" and „LH2" (insert the
washers „BS" in between). Do not tighten the screws too far. The steering mechanics cannot be moved easily, and
forceful tightening of screws may damage the plastics at the steering arm.
LH1
LH2
S4
S2
S5
MA1
MR1
BS
KK1
MA1
LH1
KK1
MR1
KK1
MR1
BS
LP
S4
MA1
LH2
KK1
55