Rear Differential - Reely ROAD 23 72 11 Notice D'emploi

b) Rear Differential
The rear differential also has two parts already pre-assembled. These are the actual differential (part „HD") and the
drive cogwheel „Z3" on the „AC3" axle (see dotted lines around the parts in the figure below).
K1
HD
K3
ST1
SR1
• First place the two large „K1" ball bearings on the left and right of the pre-assembled differential „HD". Then insert it
into the casing part „G3" (for orientation, see figure below to the left).
• Fasten the casing lid „G5" with 4 tapping screws „S1" (thread length 10mm). Ensure that the casing lid is attached in
the right orientation; see circle mark in the figure below to the right.
5x S1 (10mm)
AC3
Z3
K6
ST1
SR1
MS1
KM1
G3
G4
K5
Z4
AC4
K4
K3 Z2
AC2
G5 S1
4x S1 (10mm)
G5
K5
G3
K1
51