Reely ROAD 23 72 11 Notice D'emploi page 50

• Treat the cogwheels with a bit of gear grease.
• Replace the upper casing part „G2" and attach it with 6 tapping
screws „S1" (thread length 10mm).
• Afterwards, the cardan attachment „KM1" must be secured with
a grub screw.
First put a bit of thread locker onto the thread of the
grub screw „MS1"! Otherwise, the grub screw will loosen
after a few minutes of driving and the engine will be
blocked.
• The front differential is now finished.
50
S1
MS1
G2
KM1
MS1 KM1