Protective Cover - BIOTRONIK CRM Reocor D Manuel Technique

66
Figure 2: Correct positioning of the protective cover
Figure 3: Unlocking the protective cover
Caution!

Operating Notes

Protective Cover

The protective cover is locked when the cover has
been pushed to the stop, passing two snap-in points
and when the lever is resting on the rail (see Figure 2).
Correct:
To release the protective cover (see Figure 3):
Push the release lever up with one hand.
At the same time, use your other hand to slide
down the protective cover.
To lock the protective cover:
Slide the protective cover upwards along the rail
until it locks into place (see Figure 2).
The protective cover can be removed completely for
cleaning. Push the cover all the way down to the stop
and then remove it.
During use of Reocor D, the protective cover must be
locked to prevent inadvertent resetting of the rotary
switch and control dial, and thus of the programmed
parameters.
False: