Visual And Acoustic Signals - BIOTRONIK CRM Reocor D Manuel Technique

61
Warning
Acoustic signal for 2 s A pulse amplitude of
Fast sequence of
sounds
Acoustic signal and
flashing of the Pace
and Sense LEDs
Low battery LED
flashes.
a) When using the battery type MN 1604 Duracell

General Description

Visual and Acoustic Signals

• During the self-test after switching on Reocor D,
all LEDs light up and brief acoustic signals can 
be heard. The self-test is completed after a few
seconds.
• If the self-test does not find any errors, the LEDs
and warning signals turn off.
• When the self-test finds a defect, all LEDs flash
continuously and warning signals sound.
• A required battery replacement is indicated by the
flashing red Low battery LED.
• The Sense (green) LEDs signal sensing of a P wave
or R wave.
• The Pace (yellow) LEDs signal pulse delivery.
• The LEDs and acoustic signals also provide the
following warnings during operation:
Meaning
or a rate of 180 ppm is
>
programmed.
Impedance outside of the
permissible range
High rate protection has
been triggered;
self-test failed.
ERI has been reached.
Error correction
1 V Check whether the set
<
values are suitable for
the patient.
Check whether all
connectors are
securely plugged in.
Check whether the
leads have the desired
position.
Turn the device off and
return it to BIOTRONIK.
Replace the battery;
about 36 hours
service time remain.
® ®
, Procell
a)
of