Publicité
The position of the harness and control unit on the vehicle is chosen by the fitter/installer; the harness
can be connected to the vehicle with disconnection of the front wiring in the area under the dashboard,
Body Computer side (on the left for LHD versions and on the right for RHD versions).
The only restriction for fitters/installers is to place the electronic device in a dry area, because the TUM
control unit is not water-proof.
The three possible installation modes are shown below.
1. Horizontal
2. Vertical (connectors located at the bottom)
3. Vertical (connectors located at the side)
R
. 0
EV
A
. T
LL RIGHTS RESERVED
HE CIRCULATION AND REPRODUCTION OF ALL OR PART OF THIS GUIDE BY ANY MEANS IS PROHIBITED
NEW DUCATO
.
Publicité
