ZANOLLI SYNTHESIS 06/40V E Mode D'emploi page 67

5.5 SWITCHING OFF THE OVEN
Press the key
The heating stops while the air recycling
fan and mesh continue working, if on, until
the temperature drops below 150°C. After
this the main contactor de-energizes
leaving only the circuit board powered to
feed the clock and programmed switching
on functions.
During the switching off phase the rear illumination remains on and the
word "OFF" flashes. During this phase the oven can be switched back on
and the mesh can be started or stopped.
To prevent the oven being accidentally switched on, check the display
indicates the precise desired day and time of switching on, or, if automatic
switching on is not desired, that the words "start: off" appear.
5.6 ALARMS
The functioning of the oven is continually checked, setting off an alarm
procedure if any faults arise.
5.6.1 "OVER 1"
If the temperature measured by probe 1 exceeds 350°C or if the probe
breaks, the temperature value on the display is replaced by the flashing
phrase "OVER 1" and the alarm intermittently sounds.
Switch off the alarm by pressing the key
The oven continues working and only probe 2 is used to measure the
temperature. The control temperature is also automatically decreased by
40°C.
This variation in the temperature corrects the only value read in the
hottest part of the oven and simulates an approximate value to the
effective value which was previously set by supplying the average of
values between the hottest and coldest points. This allows the oven to be
used even when a probe breaks.
5.6.2 "OVER 2"
If the temperature measured by probe 2 exceeds 450°C or if the probe
breaks, the temperature value on the display is replaced by the flashing
phrase "OVER 2" and the alarm intermittently sounds.
Switch off the alarm by pressing the key
25
to switch off the oven.
SYNTHESIS 06/40V E
.
.
OPERATION