Agilent Technologies Turbo-V Remote Panel Notice De Mode D'emploi page 284

17 Technical Information
Programming
This menu contains all the parameters that have a direct effect on
driving of the pump.
284/304
HIGH SPEED: Sets (in Hz) the speed of rotation of the pump
when the low-speed function is not active.
LOW SPEED: Sets (in Hz) the speed of rotation of the pump
when the low-speed function is active.
SOFT START: enables (YES) or disables (NO) the soft start
function. This parameter is visible only if the controller is
configured in FRONT mode.
EXTERNAL FAN CNF: Makes it possible to select driving mode
of the external cooling fan. Possible options:
ALWAYS ON: the cooling fan is always ON
OFF_LIMPOWER: 10 seconds after the pump has reached
NORMAL status, the fan is switched off and the driving
power of the pump is reduced to 50 W
SERIAL: the cooling fan is controlled directly via the serial
port.
EXTERNAL FAN SET: enables/disables the possibility to drive
the external cooling fan. The function EXTERNAL FAN CFG is
useless when EXTERNAL FAN SET is set to OFF.
VENT VALVE MODE: makes it possible to select driving of the
vent valve
AUTOMATIC: the valve is controlled by the controller
ON COMMAND: the valve is controlled by the serial port.
VENT VALVE DELAY: Sets the delay, expressed in seconds,
between stopping of the pump and opening of the vent valve.
WATER COOLING: indicates whether the pump is cooled with
water or not. The controller limits the power supplied to the
pump according to this setting.
ACTIVE STOP: enables (YES) or disables (NO) active braking.
Turbo-V Remote Panel User Manual / 87-900-987-01 (E)