Agilent Technologies Turbo-V Remote Panel Notice De Mode D'emploi page 230

16 Instructions for Use
Use
Front Panel Description
Figure 3
1
2
3
4
5
230/304
Turbo-V Remote Panel
Keyboard push-button to recall on the display the cycle number, cycle time and
pump life.
Keyboard push-button for LOW SPEED mode selection. It is active only when the
front panel operation has been selected. Pressed once, the pump runs at "stand-
by" speed. To unselect the mode, press the push-button again.
Keyboard push-button to recall on the display the pump current, pump temperature,
pump power and rotational speed. It is always active regardless of the operating
mode selected. Push-buttons 3 and 4, if pressed together for at least 2 seconds, put
the controller in a routine where it is possible to program some operation
parameters.
Keyboard push-button for START, STOP, RESET mode selection. It is active only
when the front panel operation has been selected. By pressing once the starting
phase begins; if pressed again it stops the pump. If the pump has been stopped
automatically by a fault, this push-button must be pressed once to reset the
controller and a second time to restart the pump.
LCD back-lighted alphanumeric display: dot matrix 2 lines x 16 characters.
Turbo-V Remote Panel User Manual / 87-900-987-01 (E)