Agilent Technologies Turbo-V Remote Panel Notice De Mode D'emploi page 242

17 Technical Information
Controller Connection
Controller Connection
P1 – Input
Figure 4
All the logic input to the controller must be connected at J1 mating
connector.
With the provided J1 mating connector (shipped with pin 3 and pin 8
shorted) make the connections with AWG 24, (0.24 mm
wire to the pins indicated in the figure to obtain the desired
capability.
The following table describes the signals available on the connector.
242/304
P1 Input Connector
Turbo-V Remote Panel User Manual / 87-900-987-01
2
) or smaller
(E)