Agilent Technologies Turbo-V Remote Panel Notice De Mode D'emploi page 254

17 Technical Information
J2 – Serial Connector
For example, the Transmit data signal from controller (pin 2) must be
connected to the host computer's receive data line (pin 2) and vice
versa. Consult the host computer's instruction manual for its serial
port connections.
Agilent cannot guarantee compliance with FCC regulations for radiated
NOTE
emissions unless all external wiring is shielded, with the shield being
terminated to the metal shroud on the 0-subconnector. The cable should be
secured to the connector with screws.
Serial Communication Descriptions
This unit can communicate by the "Window" protocol. This protocol
can be used as well with 232 or 485 media.
254/304 Turbo-V Remote Panel User Manual / 87-900-987-01 (E)