Agilent Technologies Turbo-V Remote Panel Notice De Mode D'emploi page 227

Installation
The Turbo-V Remote Panel must be connected to the controller by
connection cable (see orderable parts table), as shown in the picture
below. All the necessary power/signals are present on this cable, so
any external power supply is not necessary.
In order to drive the purge and vent valves using external commands,
use the IP54 cable version, enter the configuration menu, set the
"valve setting" on the value "on command", and connect the cables as
shown in the figure. The valves are n.c., providing 24V between vent
purge and common terminal the valves will open.
Figure 1
Turbo-V Remote Panel User Manual / 87-900-987-01
FRONT VIEW
COMMON
VENT
(E)
Instructions for Use
Installation
PURGE
16
227/304