Corghi Pro 750 Manuel D'utilisation page 107

2 Turn the wheel until the central element of the corresponding position indicator lights
up.
3 Apply the adhesive weight manually in the position in which the relative plane was
measured, using the centre of gravity of the weight itself as reference. In this phase,
one display shows the unbalance value of the side to be balanced and the other shows
the message "H.12" that indicates the correct position of application as shown in figure
19.
WARNING
The machine allows the operator to select the method for applying the CLIP adhesive
weight at 6 o'clock (if the laser indicator is present) based on his requirements.
To change the application position for the adhesive weights, follow the instructions in
the set up menu "Adhesive weight application position ".
• Manually applied adhesive weights with laser device enabled (if provided)
1 Select the first side to be balanced.
2 Turn the wheel until the central element of the corresponding position indicator lights
up together with the laser line.
3 Apply the adhesive weight manually in the position in which the relative plane was
measured, using the centre of gravity of the weight itself as reference. In this phase, one
display shows the unbalance value of the side to be balanced and the other shows the
message "H.6" that indicates the correct position of application as shown in figure 19.
"Shift planes" programme (only with ALU P programmes)
This function is automatically enabled when an ALU P programme is selected.
It modifies the former selected positions for the application of adhesive balancing weights,
in order to allow perfect wheel balancing using commercially available adhesive weights
in multiples of five grams.
The accuracy of the machine is thereby improved,
avoiding rounding-off or cutting the weights to be ap-
plied to come closer to the actual unbalance values.
Service Pro 750 Operator's manual
UK
19
107