Corghi Pro 750 Manuel D'utilisation page 103

5. ENTERING DIMENSIONS IN THE
MOTORCYCLE PROGRAMMES
The operations described below are valid if the
motorcycle setting (byke) has been activated in the
"vehicle type" set up.
- Fit the appropriate extension on the inner measur-
ing arm (Fig.16a).
- To acquire the wheel dimensions, follow the instruc-
tions in the paragraph "Entering wheel dimensions".
6. WHEEL SPIN
Press the key on the display.
CAUTION
During machine use, personnel may not be present in the area enclosed by the sec-
tioning in Fig. 5a/5b.
Wheel spins take place automatically by lowering the guard or pressing the
with the guard lowered.
A special safety device stops rotation if the guard is raised during the spin; in this case,
the "A Cr" message is displayed.
CAUTION
Do not operate the machine without the guard and/or if the safety device has been
tampered with.
CAUTION
Never raise the guard before the wheel has come to a stop.
CAUTION
If the wheel keeps spinning permanently due to a fault on the machine, switch off the
machine using the main switch or disconnect the plug from the power supply board
(emergency stop) and wait until the wheel stops before raising the guard.
Service Pro 750 Operator's manual
WITHOUT GUARD
WITH GUARD
16a
key
UK
103