Corghi Pro 750 Manuel D'utilisation page 98

- Check the values measured and then return the arm to the rest position.
- If an incorrect value has been acquired during the measurement phase, move the arms
to the rest position and then repeat the operation.
Measurements can be taken also by moving one measuring arm at a time. In this case,
sensors can be used with no preset order. Pay maximum attention to the measured data
since they are influenced by the stored ones.
After setting geometric dimensions correctly and returning the sensors to the rest posi-
tion, the unbalance values recalculated according to the new dimensions are displayed.
If the inner sensor (diameter and distance) fails to operate or
- Use the keypad to enter the wheel geometric data by following the procedure described
below:
- press the
- measure the width of the rim using the calliper provided (Fig. 12)
- modify the width value (-b-) displayed by pressing the
desired value is set.
The displayed values can be increased or decreased quickly by keeping the keys
pressed.
The width can be set in millimetres by changing the setting of the unit of measurement
in the machine's set-up menu.
- press the
entry (-d-)
- read the rated rim diameter value on the tyre
- modify the displayed diameter value by pressing the
98
with the inner manual sensor
button
key to confirm the previous value and set the machine for diameter
Operator's manual Service Pro 750
keys until the
keys until the