Corghi Pro 750 Manuel D'utilisation page 133

The wheel is not locked correctly.
Tighten the securing ring nut correctly.
➥
Several spins are to be performed to balance the wheel
The machine was jolted during the spin.
Repeat the spin, taking care not to disturb the machine while measuring is in progress.
➥
The machine does not firmly rest on the floor.
Make sure that the floor support is firm.
➥
The wheel is not locked correctly.
Tighten the securing ring nut correctly.
➥
The machine has not been calibrated correctly.
Carry out the sensitivity calibration procedure.
➥
The entered geometric data are not correct.
Check that the data corresponds to the dimensions of the wheel and correct, if necessary.
➥
Perform the width sensor calibration procedure.
➥
LED light and/or laser indicator are NOT working
Check if the device(s) is (are) configured correctly as shown in the paragraphs "SET UP -
➥
LED light " and "SET UP - Laser indicator". If the problem persists after checking the correct
device configuration, call the technical support centre.
CAUTION
The "Spare parts" handbook does not authorise the user to carry out work on the machine with
the exception of those operations explicitly described in the User Manual. It only enables the
user to provide the technical assistance service with precise information, to minimise delays.
CAUTION
The company is not to be held responsible for any claims deriving from the use of non-original
spare parts or accessories.
CAUTION
Unplug the machine from the socket and make sure that all moving parts have been locked
before making any adjustments or maintenance work.
Do not remove or modify any part of the machine (except for service interventions).
WARNING
Keep the working area clean.
Never use compressed air and/or jets of water to remove dirt or residues from the machine.
Take all possible measures to prevent dust from building up or raising during cleaning
operations.
Keep the wheel balancer shaft, the securing ring nut, the centring cones and flange clean. These
Service Pro 750 Operator's manual
MAINTENANCE
UK
133