Corghi Pro 750 Manuel D'utilisation page 79

- Fix the guard support to the rear section of the machine with the four included screws
(A, Fig.4);
- Fasten the guard tube on the pivot using the M10
screw supplied (B, Fig.4);
- Fit the spring included in the equipment (C,
Fig.4);
- Connect the microswitch cable, located inside
the guard mounting, to the cable exiting from
the hole drilled in the back of the machine (D,
Fig. 4a);
Service Pro 750 Operator's manual
Guard assembly (fig. 4/4a)
3
UK
4
4a
79