Corghi Pro 750 Manuel D'utilisation page 105

• Manually applied adhesive
weights
- Select the first side to be
balanced.
- Turn the wheel until the
central element of the cor-
responding position indica-
tor lights up.
- Apply the indicated balanc-
ing weight in the position of
the rim corresponding to 12
o'clock.
WARNING
The application position of the adhesive weight can be changed from 12 o'clock to 6 o'clock
by following the instructions in the set up menu "Adhesive weight application position ".
WARNING
- for applying the adhesive weight in the MOTORCYCLE (ALU) programmes, always use
12 o'clock as the reference regardless of the setting in "SELECTION OF ADHESIVE
WEIGHT APPLICATION POSITION".
IMPORTANT
in ALU1 and ALU2 programmes the unbalance displayed by the machine on the outer side
refers to the adhesive weight centre of gravity at the swinging unit bearing flange, (Fig. 17)
• Manually applied adhesive weights with laser device enabled (if provided)
- Select the first side to be balanced.
- Turn the wheel until the central element of the corresponding position indicator lights
up together with the laser line.
- Apply the indicated balancing weight in the position on the rim corresponding to 6
o'clock.
Some slight residual unbalances may remain at the end of the test spin due to the
considerable difference in shape that may be found on rims having the same rated
dimensions. Therefore modify the value and position the previously applied weights
for accurate wheel balancing.
9. APPLYING BALANCING WEIGHTS IN
ALU1P OR ALU2P PROGRAMMES
• Adhesive weights applied with the weight-holder device (if provided) and after chang-
ing the application position from 12 o'clock with the CLIP in the "Adhesive weight
application position" setup menu
1 Select the first side to be balanced.
Service Pro 750 Operator's manual
17
UK
105