Corghi Pro 750 Manuel D'utilisation page 115

- press the key to confirm
- use the
- press the key to change the setting:
CAr on to activate the car working environment
CAr off to activate the motorcycle working environment
- press the key to confirm and exit.
Warning
Proceed as follows to balance a motorcycle
wheel:
- remove the hub;
- fit the motorcycle wheel adapter A on the
wheel balancer as shown in Fig. 21;
- insert the two screws that are supplied in the
holes on the wheel contact flange;
- tighten the screws on the adapter making
sure that it rests on the flange correctly;
- montare l'albero da moto sull'adattatore;
- mount the wheel after selecting the centring
cones (one for each side of the wheel), tighten with the
appropriate ring nut using the spacers necessary for
coupling the securing cones to the threaded part of
the shaft.
- mount the relative extension (Fig.22) on the internal
measuring arm.
- set the wheel data as shown in the paragraph "Enter-
ing wheel dimensions".
Important
the wheel must be fixed to the flange so as to avoid
any movement of the two during the spin or braking phases.
Best results can be achieved if the adhesive weights are positioned with the outer edge
flush with the rim edge.
Service Pro 750 Operator's manual
keys to search for CAr on (or CAr oFF if previously set)
21
UK
22
115