Corghi Pro 750 Manuel D'utilisation page 88

STANDARD ACCESSORIES
The following parts are supplied together with the machine.
Weight pliers
Threaded hub
Calliper for wheel width measurement
Hexagon wrench, size CH 12
Calibration weight
Power cable
4 cone kit
Small wheel fixing cap protection
Spacer cap
Small wheel fixing cap
Quick fastener ring for locking wheel
Dima calibration
OPTIONAL ACCESSORIES
Please refer to the relevant accessories catalogue.
GENERAL CONDITIONS OF USE
The equipment is intended for professional use only.
CAUTION
Only one operator at a time can work with the machine.
The wheel balancers described in this manual must be used exclusively to measure the
extent and position of car wheel unbalances, within the limits specified in the Technical
specification section. Furthermore, models equipped with motors must be provided
with a suitable guard, fitted with a safety device, which must be lowered during the spin
operation.
CAUTION
Any use of the machine other than the described use is to be considered as improper
and unreasonable.
WARNING
Do not start the machine without the wheel locking equipment.
CAUTION
Do not use the machine without the guard and do not tamper with the safety device.
WARNING
Do not clean or wash the wheels mounted on the machine with compressed air or
jets of water.
88
Operator's manual Service Pro 750