Corghi Pro 750 Manuel D'utilisation page 116

15.2. SET UP – SELECTING THE MODE
FOR ACQUIRING WHEEL DIMENSIONS
IN THE ALU1 AND ALU2 BALANCING
PROGRAMMES (ONLY THE MACHINE
VERSION WITH MANUAL SENSOR)
This configuration is used to select the method for entering dimensions for the ALU1 and
ALU2 programs and as a result the method of applying the adhesive weights inside the rim.
Proceed as follows to recall this programme:
- press the
- use the
- press the
- use the
- press the
or ALU P: to activate the ALUP balancing programmes. These programmes are used for
maximum precision balancing on light aluminium rims that require the application of both
weights on the same side (inner) in relation to the rim disk. This type of wheel balancer is
particularly suitable for application of adhesive weights on the rim, thanks to the forward
position of the wheel in relation to the body, which allows a large zone on the inside of
the rim to be accessed freely. To enter the dimensions and apply the weights, refer to the
paragraphs with ALU 1P – ALU2P
or ALU St: to memorise the rated dimensions of the rim. Self-adhesive weights are gener-
ally used to balance alloy wheels and are applied differently than for standard balancing.
Several ALU balancing programmes are available, specially designed for these types of rim.
To enter the dimensions and apply the weights, refer to the paragraphs "Entering wheel
dimensions (ALU1P and ALU2P programmes excluded)" and "Applying balancing weights"
- press the
116
key
keys to search for SEt UP
key to confirm
keys to search for ALU P (or ALU St if previously set)
key to change the setting:
key to confirm and exit.
Operator's manual Service Pro 750