Corghi Pro 750 Manuel D'utilisation page 123

- Use the buttons
- Press the button
- Use the buttons
- press the button
- 1 - Minimum display brightness value
- 8- maximum display brightness value
- press the button
15.11. SET UP - LED LIGHT (IF AVAILABLE)
The machine allows the operator to disable or modify the lighting mode.
Proceed as follows to make these settings:
- press the button
- use the
- press the key to confirm
- use the
- press the key to change the setting:
LEd oFF to disable the lighting device
or LEd 1 to activate the lighting device when acquiring
ALU1 P or ALU2 P balancing programme, at the end of a spin cycle in the
case of residual unbalances for 30 seconds, in CP (centred position) for an
additional 30 seconds
or LEd 2 in this configuration, the light will turn on, in addition to the situations indi-
cated above (in the Led1 mode) also during the entire measurement cycle,
when acquiring dimensions in all balancing programmes and in the Hidden
Weight programme when selecting the two planes behind the spokes.
Service Pro 750 Operator's manual
to search for SEt UP
to confirm
to search for dSP -3- (factory setting)
to change the setting:
to confirm and exit.
keys to search for SEt UP
keys to search for LEd 1 (LEd 2 or LEd oFF if previously set)
dimensions during an
123
UK