Corghi Pro 750 Manuel D'utilisation page 80

Fitting the external mechanical sensor and relative support
- Secure the external probe support to the balancing machine body using the three
screws supplied (A, fig. 5);
- Check that the external probe rotates freely; if not, check that the screw (B, fig. 5) does
not touch the probe pin;
- Connect the probe cable connector to the rear panel of the machine (C, fig. 5).
IMPORTANT: at the end of the assembly of the external probe, calibrate the detec-
tor as described in the paragraph "Calibration of the external MECHANICAL probe".
After completing the assembly of the machine, position it in the chosen place making
sure that the surrounding spaces are at least those indicated in fig. 5a / 5b.
80
(if available)
5a
Operator's manual Service Pro 750
5
5b