Corghi Pro 750 Manuel D'utilisation page 111

during the last spin performed which must therefore refer to the wheel being serviced.
• Press the key.
• Use the
• Press the key to activate the optimisation procedure.
Programme activation is indicated by the illumination of the LED
OP.1 H.12
- bring the valve to the "12 o'clock" position and press
- make a mark on the tyre 180° from the valve
- remove the wheel from the wheel balancer
- go to the tyre changer and move the mark made in correspondence with the valve
OP.2 180
- press the
- remount the wheel on the wheel balancer
- move the valve to the 12 o'clock position
OP.3 H.12
- press the
OP.4
- perform a spin
- turn the wheel until it is in the position shown by the position indicators
- use chalk to make a double mark on the outer side of the tyre at the 12 o'clock
position
Note: in this phase, press the
the first time the key is pressed, the actual unbalance values of the wheel as
currently mounted on the wheel balancer; the second time the key is pressed,
OP.5
the obtained unbalance value continuing with the last phase of the optimisa-
tion procedure with the improvement percentage; when the key is pressed for
the third time, the machine prepares for the last phase of the OPT programme
- remove the wheel from the wheel balancer
- on the tyre changer, move the double mark made in correspondence with
the valve
- press the
Service Pro 750 Operator's manual
keys to search for OPt.
OPERATING PHASES
key to confirm.
key to confirm.
key to confirm and end the unbalance optimisation procedure.
on the display panel.
key to display:
to confirm
UK
111