Corghi Pro 750 Manuel D'utilisation page 106

2 Turn the wheel until the central element of the corresponding position indicator
lights up. Keeping the wheel in position with the clamping brake, a display will
now show the quantity of the weight to be applied in gr/ounces and the other will
display the distance in mm alternatively to the plane identification abbreviation
(A-1 for Inner Plane/A-2 for Outer Plane).
3 Position the adhesive weight inside the cavity of the weight-holder device (Fig.
18,a,b).
4 Remove the adhesive protective film (Fig. 18c).
IN THE MACHINE VERSION WITH AUTOMATIC SENSOR move the sensor until it
5
reaches the indicated position. During this phase, the unbalance value of the side
to be balanced is shown on one display, whereas the numerical value updated ac-
cording to the sensor position, which becomes zero when the position for application
of the weight is reached, is shown on the other display.
IN THE MACHINE VERSION WITH MANUAL SENSOR with the wheel in a centred
position, the machine indicates the unbalance value on a display, whereas the
other display shows the message "d1" or "d2" alternately to the distance value of
the plane corresponding to the body.
Move the sensor to the position shown on the display in which the message "d1"
or "d2" appears alternately to the distance value (the distance is read on the rule).
6 Turn the end of the measuring arm until the weight adhesive strip is in line with the
rim surface.
7 Press the key (Fig. 18d) to eject the weight and make it stick to the rim.
8 Return the measuring arm to the rest position (Fig.18e).
9 Repeat the operations to apply the second balancing weight.
10 Perform a test wheel spin to check the balancing accuracy.
The rim surface must be perfectly clean to make the weight stick efficiently to the rim. If
necessary, clean the surface using suitable cleansing products.
a
• Manually applied adhesive weights
1 Select the first side to be balanced
106
b
d
c
e
Operator's manual Service Pro 750
18