GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the en-
gine. The operator must release the lever after each gear
change to allow it to return to its central position. Neutral
position (N) is between the first and second gears.
First gear is engaged by pushing the lever downwards;
for other gears push it upwards.
The position of the gear shift lever on the shaft can be
varied as follows: loosen the screw, pull the lever out,
and place the lever in a new position on the shaft.
Tighten the screw once operation is completed.
CAUTION*: Do not shift gears without
disengaging the clutch and closing the
throttle. The engine could be damaged
by overspeed.
WARNING*: Do not downshift when trav-
elling at a speed that would force the en-
gine to overrev in the next lower gear,
or cause the rear wheel to lose grip.
6
5
4
3
2
N
1
1
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USING THE MOTORCYCLE
NOTE*: If you are not familiar with the
motorcycle operation, read paragraphs
on "CONTROLS" before riding this mo-
torcycle.
PRE-RIDE CHECKS
Any time you ride your motorcycle, make a general in-
spection first and proceed to check the following:
- check fuel level and engine oil level;
- check the brake and clutch fluids level;
- check the steering by turning the handlebar both ways,
fully home;
- check the tyre pressure;
- check the chain tension;
- check the throttle twistgrip and adjust it, if necessary;
- The two screw taps positioned on tanks left rear side,
shall always be left in fully OPEN position.
- turn the key in the ignition switch to ON: check dash-
board display lighting;
- check that parking lights, low beam, and high beam
come on, as well as the relevant warning light;
- operate turning indicators, and check that the relevant
warning light comes on;
- check that the rear stop light comes on.
INSTRUCTIONS FOR RUNNING-IN
The exclusivity of the design, coupled to the high quality
of the materials used and the accuracy of the assembly,
guarantee the higher comfort right from the start. Never-
theless, during the first 200 km or 4 hours, you will have
to THOROUGHLY respect the following rules. FAILURE TO
COMPLY WITH THEM COULD SERIOUSLY AFFECT MOTORCY-
CLE LIFE AND PERFORMANCE.
- warm up the engine by running at low revs before us-
ing the motorcycle;
- avoid quick starts and never rev up the engine when in
low gear;
- ride at low speed until the engine is warmed up;
- apply both brakes several times to settle the pads and
the discs;
- do not maintain the same speed for a long time;
- do not ride for a long time without stopping;
- NEVER drive downhill with GEARBOX IN NEUTRAL, but
shift into gear to brake with the engine if necessary,
thus preventing the fast wear of the brake pads.
- Max. speed during running-in period: 80 Km/h.
- Check the oil level after the first 4 hours of operation.
SPECIFICATIONS - OPERATION - MAINTENANCE
EN - 17