Publicité
Les langues disponibles
Les langues disponibles
E E x x t t e e n n d d i i n n g g t t h h e e b b e e d d e e x x t t e e n n d d e e r r ( ( o o p p t t i i o o n n ) )
W W A A R R N N I I N N G G
• Do not sit on the bed extender. This may cause the product to tip.
• Always lock the bed extender before you place weight on the bed extender.
C C A A U U T T I I O O N N
• Do not remove the footboard after you extend the bed extender.
• Do not raise the lower leg section while the bed extender is in use. This is to avoid the situation where the product does
not support the lower legs of a taller patient.
The bed extender allows you to extend the length of the product by 31 cm.
To extend the bed extender:
1. Pull and turn each knob 90° to unlock the bed extender (Figure 19).
2. Grasp the footboard handles.
3. Pull the footboard to extend the bed extender (Figure 20).
4. Pull and turn each knob 90° to lock the bed extender into place.
N N o o t t e e - - When locking the bed extender, listen for the "click" that indicates that the bed extender is locked. Push and pull
on the footboard to make sure that the bed extender is locked.
F F i i g g u u r r e e 1 1 9 9 – – U U n n l l o o c c k k i i n n g g t t h h e e b b e e d d e e x x t t e e n n d d e e r r
I I n n s s t t a a l l l l i i n n g g t t h h e e b b e e d d e e x x t t e e n n d d e e r r b b o o l l s s t t e e r r m m a a t t t t r r e e s s s s
For mattress specifications, see the MA series mattress manual.
The recommended bed extender bolster mattresses are:
C C o o m m p p a a t t i i b b l l e e b b o o l l s s t t e e r r m m a a t t t t r r e e s s s s e e s s
7002-4-018
7002-4-020
7002-4-518
7002-4-520
To install the bed extender bolster mattress:
1. See Extending the bed extender (option) (page 30).
EN
30
F F i i g g u u r r e e 2 2 0 0 – – E E x x t t e e n n d d i i n n g g t t h h e e b b e e d d e e x x t t e e n n d d e e r r
D D i i m m e e n n s s i i o o n n
330 mm x 710 mm x 180 mm
330 mm x 710 mm x 200 mm
330 mm x 710 mm x 180 mm
330 mm x 710 mm x 200 mm
KK-7500 REV 08
Publicité
