Stryker SV2 Manuel D'utilisation page 20

P P l l u u g g g g i i n n g g o o r r u u n n p p l l u u g g g g i i n n g g t t h h e e p p r r o o d d u u c c t t
W W A A R R N N I I N N G G
• To avoid the risk of electric shock, this equipment must only be connected to a supply mains with protective earth.
• Always store the power cord to avoid the risk of entanglement, damage to the power cord, or potential shock hazards. If
the power cord is damaged, remove the product from service and contact the appropriate maintenance personnel.
• Always allow enough clearance between the head end of the product and the adjacent wall, so you can unplug the
power cord from the wall outlet during an emergency.
• Always store the power cord before transporting the product.
To plug in the product, plug the power cord into a protective earthed outlet.
To unplug the product, grasp the mold near the outlet and pull the cord in a direction parallel to the floor (not at an angle).
C C h h a a r r g g i i n n g g t t h h e e b b a a t t t t e e r r y y
W W A A R R N N I I N N G G
• Always disconnect the power cord from the wall outlet if you detect overheating of the battery, control cables, or
pendants. Do not use the product again until it has been inspected, serviced, and confirmed to work as intended by
authorized maintenance personnel.
• Do not open a dead battery.
• Do not throw the battery into a fire.
• Do not spill liquid onto the battery or submerge the battery in liquid.
C C A A U U T T I I O O N N
• Always plug the product into a wall outlet (regulated AC-power source) when not in use to maintain a sufficient battery
charge and to maximize product performance while operating on battery power.
• Always replace batteries that have corrosion at the terminals, display cracking, have expanded or bulging sides, or no
longer can maintain a full charge.
• Only use authorized batteries when replacing the batteries. Use of unauthorized batteries may lead to unpredictable
system performance.
S S V V 2 2 is equipped with a battery backup system that charges when the product is plugged into a wall outlet. The battery
backup system allows the operator to use the product when the product is unplugged, during a power failure, or while
transporting a patient. Battery backup functionality activates when you unplug the product.
Always check battery backup function according to the preventive maintenance checklist (see Preventive maintenance
(page 41)). Always replace the battery if it does not perform as intended during preventive maintenance.
To charge the battery, connect the product to a wall outlet. The battery has a full charge within 10 to 12 hours.
S S t t o o r r i i n n g g t t h h e e b b a a t t t t e e r r y y l l o o n n g g t t e e r r m m
W W A A R R N N I I N N G G - - Always unplug the battery cable from the control box before you store the product for a long period of time.
C C A A U U T T I I O O N N - - Do not place or store heavy objects on the product.
Store the battery per the environmental conditions listed in the specifications section (see Specifications (page 8)).
To store the battery:
1. See Plugging or unplugging the product (page 16).
2. See Plugging or unplugging the battery cable (page 15).
EN 16 KK-7500 REV 08