Stryker SV2 Manuel D'utilisation page 25

A A c c t t i i v v a a t t i i n n g g a a n n d d r r e e s s e e t t t t i i n n g g t t h h e e C C P P R R r r e e l l e e a a s s e e
W W A A R R N N I I N N G G - - Always make sure that all persons and equipment are away from the area below and around the backrest
before you activate the CPR release. The CPR release is for emergency use only.
If the backrest is raised and you need quick access to the patient, you can position the product to 0° by activating the CPR
release.
You can find the instant CPR release lever at the head end section on both the left and right sides of the backrest.
To activate the CPR release:
1. Grasp either lever (A) and pull outward (Figure 13).
2. Guide the backrest down to the flat position.
To reset the backrest motor after activating the CPR release, press the backrest down button on the control panels or the
CPR button on the nurse control panel.
F F i i g g u u r r e e 1 1 3 3 – – C C P P R R r r e e l l e e a a s s e e
R R e e m m o o v v i i n n g g o o r r r r e e p p l l a a c c i i n n g g t t h h e e h h e e a a d d b b o o a a r r d d
W W A A R R N N I I N N G G - - Always properly orient the headboard when replacing the headboard to avoid entrapment.
You can remove the headboard for patient accessibility and cleaning.
To remove the headboard:
1. Hang the patient control pendant onto the head end siderail.
2. Grasp the handles and lift the headboard straight up and off the product (Figure 15).
To replace the headboard:
1. Align the curved headboard corners with the foot end of the bed (Figure 14).
2. Align the headboard pegs (A) with the plastic sleeves (B) at the head end of the product (Figure 15).
3. Lower the headboard until it seats into the plastic sleeves (B) (Figure 15).
KK-7500 REV 08 21 EN