Stryker SV2 Manuel D'utilisation page 21

S S t t o o r r i i n n g g t t h h e e p p o o w w e e r r c c o o r r d d
W W A A R R N N I I N N G G
• Always store the power cord before transporting the product.
• Always store the power cord to avoid the risk of entanglement, damage to the power cord, or potential shock hazards. If
the power cord is damaged, remove the product from service and contact the appropriate maintenance personnel.
C C A A U U T T I I O O N N - - Do not squeeze or pinch the power cord in the bed frame.
To store the power cord, wrap the power cord around the cord wrap (A) underneath the head end of the product (Figure 6).
T T r r a a n n s s p p o o r r t t i i n n g g t t h h e e p p r r o o d d u u c c t t
W W A A R R N N I I N N G G
• Always store the power cord before transporting the product.
• Always lock the siderails in the full up position with the sleep surface horizontal in the lowest position when transporting
a patient.
• Always keep limbs, hands, fingers, and other body parts clear of mechanisms and gaps.
• Always make sure that there are no obstacles near the product. Injury to the patient, operator, bystanders or damage to
the frame or surrounding equipment could occur if you collide with an obstacle.
• Do not attempt to move the product laterally. This may cause the product to tip.
C C A A U U T T I I O O N N
• Do not use the siderails as a push or pull device. Always move the product using the integrated handles in the
headboard and footboard.
• Always remove the patient lift pole before transporting the product.
• Do not use the IV pole as a push or pull device.
• Always make sure that the IV pole is at a low height during transport.
To transport the product:
1. Lock the siderail control panel and patient control pendant functions (see Nurse control pendant (page 28)).
2. Unplug the power cord from the wall outlet.
3. See Storing the power cord (page 17).
4. Store the control pendants.
5. Retract the linen tray (see Extending or retracting the linen tray (option) (page 31)).
6. Lower the IV pole.
7. Turn in the oxygen bottle holder toward the product.
8. Raise and lock the siderails in the full up position (see Raising or lowering the siderails (page 24)).
9. Release the brakes (see Applying or releasing the brakes (page 18)).
10. Push the product from the headboard or footboard.
KK-7500 REV 08
F F i i g g u u r r e e 6 6 – – S S t t o o r r i i n n g g t t h h e e p p o o w w e e r r c c o o r r d d
17 EN