Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SIDERAIL / ENDRAIL HANDLE ASSEMBLY REPLACEMENT
TOOLS REQUIRED:
• 3/32 in. Allen Wrench
PROCEDURE:
1.
Raise the siderail / endrail needing repair to the upper position and
apply the brakes.
2.
Using a 3/32 in. Allen wrench, remove the set screw holding the handle
assembly to the shaft. Remove the defective handle assembly.
3.
Install the new handle assembly and verify proper operation of the
siderail / endrail before returning the stretcher to service.
ENDRAIL CENTRAL COLUMN ASSEMBLY REPLACEMENT
WARNING
Only service technicians from Stryker or service personnel trained by Stryker should perform this procedure. Failure to
comply can result in serious damage to the bed and/or severe injury to users or patients.
TOOLS REQUIRED:
• #1 Phillips Screwdriver
• #2 Phillips Screwdriver
• Small Regular Screwdriver
• 1/2 in. Socket
• 3/8 in. Drive Ratchet
• 3/8 in. Combination Wrench
• 3/32 in. Allen Wrench
• Medium Strength Thread Locker (or equivalent)
• Adjustable Supports (or equivalent)
PROCEDURE:
Note
When ordering a central column assembly, specify if
the stretcher is equipped with the double safety lock.
Proper warning labels are affixed to assemblies with
out the double safety lock.
1.
Remove the mattress, raise the rails to the
highest position and apply the brakes.
2.
Using a #1 Phillips screwdriver, remove the eight
screws (A) holding the bottom half of the lower
plastic cover (B) to the top half of the lower plastic cover (C).
3.
Insert a small regular screwdriver between the two halves of the lower plastic cover to separate them. Use caution
to avoid scratching the covers or damaging the upper cover snap pins.
Return To Table of Contents
1-52
Service
A
P
U,V
N
R
S
U,V
Q
T
O
Figure 23
1900-009-002 REV B
Figure 22
G
J
A
L
K
H
F
A
C
B
B
M
E
B
A
D
www.stryker.com
J
L
F
W
A
Publicité
Chapitres
Table des Matières
