Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UPPER PLASTIC COVER REPLACEMENT (CONTINUED)
6.
Using a #1 Phillips screwdriver, remove the eight screws (G) holding the top half of the upper plastic cover (H) to
the bottom half of the upper plastic cover (X).
7.
Insert a small regular screwdriver between the two halves of the upper plastic cover to separate them. Use caution
to avoid scratching the covers or damaging the lower cover snap pins. Remove the defective upper cover.
8.
Reverse the above steps to install the new upper cover.
9.
Verify proper operation of the rails before returning the stretcher to service.
LOWER PLASTIC COVER REPLACEMENT
TOOLS REQUIRED:
• #1 Phillips Screwdriver
• Small Regular Screwdriver
PROCEDURE:
Note
Refer to Figure 24 (Moving Access
procedure.
1.
Raise the rail to be repaired to the highest position and apply the brakes.
2.
Using a #1 Phillips screwdriver, remove the eight screws (A) holding the bottom half of the lower plastic cover (B)
to the top half of the lower plastic cover (C). If repairing a siderail, open the access doors to reach the two screws
located at the ends of the top half of the lower plastic cover.
3.
Insert a small regular screwdriver between the two halves of the lower plastic cover to separate them. Use caution
to avoid scratching the covers or damaging the upper cover snap pins. Remove the defective lower cover.
4.
Reverse the above steps to install the new lower cover.
5.
Verify proper operation of the rails before returning the stretcher to service.
www.stryker.com
Service
Doors, page 1-56)
or Figure 25 (Fixed Access Doors,
1900-009-002 REV B
page
1-60) for this
Return To Table of Contents
1-63
Publicité
Chapitres
Table des Matières
