Access Door Upper Cover Replacement; Access Door Lower Cover Replacement - Stryker CUB Pediatric Crib Manuel De Maintenance

Masquer les pouces Voir aussi pour CUB Pediatric Crib:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ACCESS DOOR UPPER COVER REPLACEMENT

TOOLS REQUIRED:
• #1 Phillips Screwdriver
• #2 Phillips Screwdriver
• Small Regular Screwdriver
• 5/32 in. Allen Wrench
PROCEDURE:
1.
Remove the access door (see "Access Door Replacement",
2.
Remove the colored label affixed to the outside of the upper cover of the access door.
3.
Using a #1 Phillips screwdriver, remove the four screws (M) holding the top half of the upper cover (N) to the
bottom half of the upper cover (W) (see Figure 28,
4.
Insert a small regular screwdriver between the two halves of the upper over to separate them. Use caution to avoid
scratching the covers or damaging the snap pins.
5.
Using a #2 Phillips screwdriver, remove the eight screws (T) holding the upper end of the posts to the upper
structural member (V).
6.
Using a 5/32 in. Allen wrench, remove the two Allen screws (U) holding the hinge (G) and the last post to the upper
structural member (V). Remove the defective upper cover.
7.
Reverse the above steps to install the access door upper cover and reinstall the access door.
8.
Verify proper operation of the access door before returning the stretcher to service.

ACCESS DOOR LOWER COVER REPLACEMENT

TOOLS REQUIRED:
• #1 Phillips Screwdriver
• #2 Phillips Screwdriver
• Small Regular Screwdriver
• 5/32 in. Allen Wrench
PROCEDURE:
1.
Remove the access door (see "Access Door Replacement",
2.
Remove the colored label affixed to the outside of the lower cover of the access door.
3.
Using a #1 Phillips screwdriver, remove the four screws (O) holding the bottom half of the lower cover (P) to the
top half of the lower cover (Y) (see Figure 28,
4.
Insert a small regular screwdriver between the two halves of the lower cover to separate them. Use caution to
avoid scratching the covers or damaging the snap pins. Remove the access door upper cover.
5.
Using a #2 Phillips screwdriver, remove the eight screws (X) holding the lower end of the posts to the lower
structural member (Z).
6.
Using a 5/32 in. Allen wrench, remove the two Allen screws (AA) holding the hinge (I) and the last post to the lower
structural member (Z). Remove the defective lower cover.
7.
Reverse the above steps to install the access door lower cover and reinstall the access door.
8.
Verify proper operation of the access door before returning the stretcher to service.
www.stryker.com
Service
page
1-66).
page
1-66).
page
1-66).
page
1-66).
1900-009-002 REV B
Return To Table of Contents
1-67

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Fl19f/h

Table des Matières