Programming The Stimulator - Boston Scientific Vercise Neural Navigator Mode D'emploi

# Feature Description
4 Connection Displays a green filled circle if the Stimulator is connected to the CP.
Status
5 Connect or Connect or disconnect from a Stimulator. When a Stimulator is not
Disconnect connected, this button reads 'Connect'. When a Stimulator is connected,
Button this button reads 'Disconnect'.

Programming the Stimulator

Configuring the Leads
Once a connection has been established between the CP, Wand and Stimulator, switch to the
Configure Tab to configure the leads that are connected to the Stimulator (See Figure 4).
Note: This step needs to be performed only once, the first time you connect to a new Stimulator.
Once a Stimulator has been configured, you can directly switch to the Program Tab after
connection has been established.
Figure 4. Configuring Leads
Vercise™ Neural Navigator Programming Manual
Programming the Stimulator
91046489-05 5 of 557