Default Settings Of The Device; Your Settings - Burkert 8025 Manuel Utilisateur

Maintenance
Message Meaning
displayed
PWR FAIL the power supply is too low.
• The voltage at the device
terminals is lower than
12 V.
• The impedance of the
current measurement loop
is too high (see chap.
3.3.1 ).
PU H LIM The pulse value times the
K factor of the device is >
1000000.
The volume input for a pulse
is too high.
PU L LIM The pulse value times the K
factor of the device is < 1.
The volume input for a pulse
is too low.
6.3.

Default settings of the device

Language
Flow rate unit
Unit of the totalizers
Number of decimal positions
K factor
4 mA current
20 mA current
Unit of pulse output
6.4.

Your settings

Language
Flow rate unit
Unit of the totalizers
Number of decimal positions
K factor
4 mA current
20 mA current
What to do
→
Adjust the supply voltage so that the
voltage at the device terminals are between
12 V and 36 V.
→
Enter a lower volume / pulse. see
chap. 5.3.5 .
→
Check the K factor value. see chap.
→
Enter a higher volume / pulse. See
chap. 5.3.5 .
→
Check the K factor value. See chap.
English PU
L/min Relay 1-
L Relay 1+
1 Relay 1 inverted
51.20 Relay 2-
000.0 Relay 2+
100.0 Relay 2 inverted
L Filtre
PU
Relay 1-
Relay 1+
Relay 1 inverted
Relay 2-
Relay 2+
Relay 2 inverted
E-49-
Flow transmitter 8025/8035
5.3.3 .
5.3.3 .
00.05
40.0
50.0
no
80.0
90.0
no
5