Electrical Connection Of A 8025 In A Compact Version Or A 8035, With En 175301-803 Male Fixed Connector - Burkert 8025 Manuel Utilisateur

Installation and electrical wiring
4.2.2. Electrical connection of a 8025 in a compact
version or a 8035, with EN 175301-803 male fixed
connector
→
Unscrew the nut [1] of the cable gland.
→
Remove the terminal block [3] from the housing [2].
→
Insert the cable through the nut [1] then through the gasket [4], through
the cable gland and finally through the housing [2].
→
Connect the wires to the terminal block [3] (see hereafter).
→
Position the terminal block [3] in steps of 90° then put it back into the
housing [2], pulling gently on the cable so that the wires do not clutter
the housing.
→
Tighten the nut [1] on the cable gland.
→
Place the seal [5] between the female connector and the
EN 175301-803 male fixed connector then insert the 2508 connector
into the fixed connector.
→
Insert and then tighten the screw [6] to ensure tightness and correct
electrical contact.
Fig. 15 : Assembling the EN 175301-803 type 2508 female connector
Fig. 16 : Pin assignment of the EN 175301-803 male fixed connector
Pulse output "minus"
Pulse output "plus"
E-21-
Flow transmitter 8025/8035