Burkert 8025 Manuel Utilisateur page 35

Installation and electrical wiring
4.2.10. Electrical wiring, panel-mounted version,
12-36 VDC, without relays
Only configure the selectors by unpowered device.
Configure the FLOW SENSOR selector (see chap. 4.2.4 ) depending on the
version of the remote flow sensor.
Connection of remote flow
sensor (see chap. 4.2.12 )
Fig. 33 : Pin assignment, panel-mounted version, 12-36 VDC, without relays
→
Insert the cable clips (see chap.
Connect the current and the pulse outputs of a panel-mounted version, 12-36 VDC, without
relays, in the same way as those of transmitter in a compact version, 12-36 VDC, without
relays, with cable glands (see Fig. 21 and Fig. 22 ).
4.2.11. Electrical wiring, panel-mounted version, 12-36
VDC, with relays
Only configure the selectors by unpowered device.
Configure the FLOW SENSOR selector (see chap. 4.2.4 ) depending on the
version of the remote flow sensor.
L- (0V)
L+ (12-36 VDC)
not used
4.2.3 ).
E-33-
Flow transmitter 8025/8035
Pulse output "minus"
Pulse output "plus"
Shieldings of both the power supply and the
pulse output cables
"Sensor Type" selector (see chap.
4.2.4 )