Inserting The Cable Clips (Versions Without En 175301-803 Male Fixed Connector); Configure The Flow Sensor Selector - Burkert 8025 Manuel Utilisateur

Installation and electrical wiring
4.2.3. Inserting the cable clips (versions without
EN 175301-803 male fixed connector)
Fig. 19 : Using the cable clips
4.2.4.

Configure the FLOW SENSOR selector

→
Before wiring the device, configure the selector on the electronic board.
Transmitter version
All
All
4.2.5. Electrical wiring of a 8025 compact and a 8035,
12-36 VDC, without relays, with cable glands
Seal the unused cable gland using the stopper supplied to make sure the
device is tight.
• Unscrew the cable gland nut, insert the obstructor and screw the nut back onto
the cable gland.
Only configure the selectors by unpowered device.
→
Lift the transparent lid after having unfastened the screw.
→
Unscrew the 4 screws then remove the cover from the device.
→
Insert the cable clips (see chap.
→
Pass the cables through the cable glands
→
Connect terminals according to pin assignment described below.
→
Before wiring the device, insert the supplied cable clips into
the cuts of the electronic board and, if fitted into the cut of
the 115/230 VAC-power supply board.
Output signal of the remote
sensor
Pulse, NPN (hall)
Sinus (coil)
4.2.3 ).
E-23-
Flow transmitter 8025/8035
Position of the FLOW
SENSOR selector
NPN
COIL