Burkert 8025 Manuel Utilisateur page 27

Installation and electrical wiring
Connection of the pulse output in NPN mode
Power supply
(*) If direct earthing is not possible, insert a 100 nF / 50 V condensator between the negative terminal of the
voltage supply and the earth.
Fig. 22 : Connection of the pulse ouput in NPN or PNP mode, of a compact version,
12-36 VDC, without relays, with cable glands
4.2.6. Electrical wiring of a 8025 compact and a 8035,
12-36 VDC, with relays, with cable glands
Seal the unused cable gland using the stopper supplied to make sure the
device is tight.
→
Unscrew the cable gland nut.
→
Insert the stopper
→
Screw the nut back.
Only configure the selectors by unpowered device.
→
Lift the transparent lid after having unfastened the screw.
→
Unscrew the 4 screws then remove the cover from the device.
→
Insert the cable clips (see chap.
→
Pass the cables through the cable glands
→
Connect terminals according to pin assignment described below.
Connection of the pulse output in PNP mode
Power supply
4.2.3 ).
E-25-
Flow transmitter 8025/8035