Assemble The 8035 - Burkert 8025 Manuel Utilisateur

Installation and electrical wiring
1
2
3
4
5
Fig. 9 : Installation of the compact 8025 into a fitting S020
4.1.2.

Assemble the 8035

The flow transmitter 8035 can be installed on a pipe using a fitting S030.
Fig. 10 : Assembly of the 8035
→
Respect the installation instructions contained in the
instruction manual of the fitting used.
→
Insert the nut [3] on the fitting and clip the ring [2] into
the groove [4].
→
Carefully insert the transmitter [1] into the fitting. If
assembly is correct, the device can no longer rotate on
itself.
Only tighten the nut by hand!
→
Secure the unit with nut [3].
→
Respect the installation instructions
contained in the instruction manual of the
fitting [1] used.
→
Insert the electronic module SE35 [2] into the
fitting S030 [1].
→
Fasten the electronic module to the fitting by
turning it at 90 °.
→
Secure the unit by tightening the screw [3].
E-16-
Flow transmitter 8025/8035