SDMO RES 9.5 EC Manuel D'installation page 118

To switch to advanced configuration mode, press the up arrow when "Adnc" (see figure 2.40) is
displayed on screen.
Press:
or
or
or
Note: Ensure that the selections made have been saved before exiting configuration mode. The controller restores the
selections most recently saved when the main switch is set to "OFF/RESET".
Figure 2.41: Advanced configuration mode (parameters for types of engine data entry, battery voltage and
engine communications), RES 9.5 EC / RES 13 EC
There are three options when the screen displays "SAVE":
Press:
To return to the first parameter, nominal voltage/frequency ("Uu" code), in order to
check or modify the selections made before saving, see figure 2.40.
or
To save the changes.
or
To cancel the changes, without saving..
The words "Yes" or "no" flash on screen when the up or down arrow is pressed and then the
controller exits configuration mode. The screen then displays the hours of operation* once more.
The main switch should now be set to "OFF/RESET".
* On the display for hours of operation, X denotes any figure between 0 and 9.
Figure 2.42: Save mode (after configuration of the generating set parameters) , RES 9.5 EC / RES 13 EC
To define the type of engine data entry, select "Ed05".
To switch to battery voltage selection mode.
To alternate between 12 and 24 VDC. For this parameter, select 12 VDC.
To switch to communications selection mode.
To select "Cn00" for this parameter.
To switch to "SAVE" mode. See figure 2.42.
42/73
E d 0 5
B t 1 2
C n 0 0
S A V E
S A V E
U u 0 1
Y E S
n o
X X X X