SDMO RES 9.5 EC Manuel D'installation page 117

ADC 2100 Controller configuration mode:
Press and hold the selection button:
Now release the selection button.
Press:
or
or
or
Next save the selections made or move to advanced configuration mode to define the
type of engine data entry, the battery voltage and communications.
Press:
or
or
Note: The grey boxes indicate the figure displayed on the controller screen and this value can be modified by
pressing the up or down arrow.
Figure 2.40: Configuration mode (nominal voltage/frequency settings, configuration of the generating set and engine type),
RES 9.5 EC / RES 13 EC
Move the main switch on the generating set to "RUN". (The
generating set engine does not start.)
Wait approximately 5 seconds; the screen displays the
program version number. (this number may be different from
the number indicated here).
Press on the down arrow, then the up arrow and repeat this
twice to switch to configuration mode. (This key combination
serves as a "password" for the controller.)
The voltage/frequency torque is adjusted selecting "Uu0l" on
60 Hz models, or "Uu06" for 50 Hz models.
To move to the next setting, generating set configuration
("Uc" code)
To select "UcOl" as the generating set configuration value, as
required.
To move to the next setting, engine type
("Ec" code).
To select "Ec05" as the engine type, as required.
To move to the next setting, advanced configuration mode or to
select save mode.
To switch to advanced configuration mode.
See figure 2.41.
To select save mode directly, without switching to advanced
configuration mode.
See figure 2.42.
41/73
Display:
. 0
1 0 4
U u 0 1
U u 0 1 60Hz
U u 0 6 50Hz
U c 0 1
E c 0 0
A d n C
E d 0 5
S A V E